Over the previous few decades, we’re seeing more and more guitar amp producers making Isolation Cabinets or “Iso Cabs” as they’re typically called by working musicians. The reason for this is simple. Sound engineers and stage technicians are always telling guitarists to show down in order that they can management the sound from the Front of House (FOH). Everyone knows the general FOH sound is at all times best when the FOH sound engineer has total management over the musical instruments degree within the venue. Sounds simple proper? Well this is the problem. The dilemma is the truth that guitar amps usually have a candy spot the place they sound the best. Unfortunately, this sweet spot is generally obtained by turning the guitar amp as much as a higher level. More technically, the guitar amp needs to be turned up to a point that the preamp tubes and energy tubes are being pushed a bit. This added quantity permits the amp to “open up” so to speak. To not sound choked or filtered by electronics that attenuate and diminish the pure tone of the amp. There are quite a few digital variables to consider that have an effect on the overall tone and feel of the amp so please take my word for it on this one, guitarist want to crank there amp for good reason.
Guitarists and producers all love the recorded sound of a cranked Marshall or Mesa Boogie guitar amp pushed to the limit. Nonetheless, most leisure venues, houses of worship, theaters, Broadmeans shows, clubs, casinos, and so on, don’t want the overwhelming stage volume that comes from cranking a 50-one hundred watt Guitar Isolation cabinet amp. Some guitarists have chosen to go the amp modeling/digital effects processor route which has come a long way. This option can sound quite good if in case you have an ear and take the time to learn to program the unit. As a matter of fact some musicians even swear by it. With that mentioned, the fact stays that the overwhelming majority of working guitarists favor to make use of the amp and setup that they’re consolationable with and have used for years to create “their tone”. That brings us back to the isolation cabinet.
Isolation cabinets allow the guitarist to make use of the exact setup that they are used to. This means all the effects pedals and the amp of their selecting, and anything else of their stage signal chain. The isolation cabinet simply replaces the speaker or speaker cabinet in the guitarist’s setup. The entire isolation cabinet has a guitar speaker and microphone mounted inside it’s enclosure. The cabinet is usually highly dampened with acoustic foam to minimize internal reflections and to dampen the overall sound radiating from the unit. Depending on the quantity of the amp, some isolation cabinets can still be quite loud and radiate quite a lot of sound externally. One other major concern with most isolation cabinets is the fact that they are usually large and heavy. These cabinets typically weigh between 60 and eighty pounds or more when loaded. However, JLH Technologies manufacturers a small, table prime isolation cabinet called the AxeTrak Pro. This unit weighs about 20 pounds, has a particularly small footprint, and is probably the most quiet of all isolation cabinets being sold at this time.
There are loads of options in the marketplace so be sure to do your homework and check them out. An isolation cabinet could possibly be the answer you have been searching for!